Sandblasting my driftwood tables

Every piece of driftwood furniture I’ve created over the past 35 years has had to go through the sandblasting process. From that point, I would then sun bleach it, lacquer it or even leave it in that raw reddish, brown, blond tones. Until very recently it was a task that I did myself with my old & sometimes unreliable gas powered air compressor. It was a very slow, tedious & usually hot job that I never looked forward to, but was always pleased with the results.IMG_4099.JPGA month ago I had a number of table pieces that were ready to be sandblasted & several that were impending orders that had a deadline. But that Saturday I selected to do the deed was one of those days that my compressor decided to not cooperate no matter what I did to fix it. It turned out to be a blessing in disguise as it forced me to find an outside source that would do my blasting for me. I took them a few pieces just to see the results of their work & was very pleased with how they turned out & how little time it took for them to do it (minutes as opposed to hours).  Needless to say, I was not totally exhausted from doing it myself & could spend more time & energy on completing the tables.DSC_0403They’re able to sandblast in a large enclosed building with a much larger capacity sand pot, thus not needing to stop to fill up with sand as I was constantly doing & with a higher volume of air pressure which made for a shorter completion time.DSC_0311

DSC_0309                                 A few pieces that I had blasted this weekDSC_0400DSC_0404DSC_0405Below is an interesting  dining table that I’m working on for Vera, a very pleasant customer from New Jersey. The next step will be exposing it to the weather for the next several months until it acquires that sun bleached finish that she requested.Driftwood dining tableAnother small but important thing that sandblasting accomplishes is enabling all the necessary cut ends to look weathered (like the top of an old fence post) rather than having the look of being fresh cut.DSC_0411

 

3 comments on “Sandblasting my driftwood tables
  1. nikkiupat says:

    The ex-sanblaster’s wife is way thankful you’re FINALLY sourcing this out!!! My resident artist is way more valuable on the “creative “end!! And this will add years to the possibilities! Now about adding that shipping department person….❤️

  2. Beautiful pieces! I would love to see how the finished pieces came out. Do you sandblast for cleaning purposes or just for the look? I’ve been wanting to build with found driftwood, but wondering – do you have to bleach every piece to kill any microbes or small critters that might break down the wood over time? That seems like a major pain, especially for large pieces. Thanks for the post!

  3. Debbie Mueller says:

    Any before/after photos?

Leave a Reply